ELFR-1 Plug-And-Play
Electronic LED Flasher Relay
Now you can finally fix
the flash rate on your motorcycle with our unique Plug And Play solution! That's
right, our Electronic LED Flasher relay directly replaces the stock flasher
relay on most Yamaha, Honda and Kawasaki motorcycles by plugging directly into
the harness in place of the OEM flasher relay! See the compatibility list.
For motorcycles with nonstandard
two wire flasher relays (not on compatibility list), this flasher relay can
still be used by removing the connector and hard wiring it. Even three wire
flasher relays can be replaced if one of the wires is a ground wire.
This unit is guaranteed to replace
any two-wire flasher relay and operate at the normal DOT blink rate for motorcycles
with stock blinkers, LED blinkers, or any combination of both, provided the
total load on the system is within 0.05A to 10A (0.6 Watts to 120 Watts!) -
which basically covers the majority of blinker products on the market!
NOTE: In some rare instances, when
there are NO incandescent loads on the blinker system (LEDs front and rear),
one pair of our Stage I Load Equalizers will also be required to prevent a wide
range of blinker problems. These problems are all associated with a lack of
resistive load on an all-LED blinker system that was designed for incandescent
lamps. Problems such as, but not limited to: the 4-way blink problem (both sides
blinking at the same time), the no-blink problem, and Integrated LED Tail Lights
staying in "blinker mode" due to non-zero blinker voltages.
